excavator track parts

Kyushan Machinery is excavator undercarriage manufacturers that mainly engaged in Komatsu excavator parts and dismantling parts: various types of original filter elements, engine oil, hydraulic oil, Komatsu mechanical structural parts, engine assembly and engine parts, hydraulic parts, electrical parts, chassis parts, etc. Boom, forearm, bucket, ripper, hydraulic cylinder, piston rod, connecting rod, swing frame, pin, bushing, idler, roller, track, chain link bolt, various high-pressure oil pipes, Hose, hydraulic pump, distribution valve, reducer, motor, final drive assembly, slewing mechanism assembly, engine assembly, four sets of engine, starter, generator, supercharger, air conditioner compressor, fuel injector, Fuel injection pump, oil pump, etc.

Excavators are most prone to high water temperature failures. Today, I shared with you the high water temperature failure caused by theexcavator water pump. How to check if the excavator water pump is working? Remove the thermostat, turn it on, run at idle speed and high speed repeatedly, press the water pipe to see if there is water passing through the water pipe, if the water pipe is hard, it means the pressure is normal, then open the water tank cover and observe whether the water flow speed is normal. What should I do if the excavator water pump leaks? Open the top cover, disassemble the fan water blocking ring, check the inside of the water pump belt, open the bottom plate of the oil pan, and confirm the specific leakage location. If the oil seal of the water pump and the pad of the water pump are damaged, they can be replaced directly.

-- Excellent flexibility of excavator belt -- High power transmission efficiency -- Reduced noise of excavator belt -- a power transmission belt featuring multiple longitudinal ribs. -- It transmits the torque by contact of the belt rib flanks and the pulley grooves. -- It has been designed with a larger contact surface area than V belts or flat belts.

Hitachi excavator undercarriage parts mainly track rollers, sprockets, idlers, carrier rollers, and tracks. Track roller: As the name implies, it plays a supporting role and is located between the lower surface of the left/right beam of the undercarriage and the crawler, depending on the tonnage of the excavator. Usually there are 5-10 on one side. Driving sprockets: plays the role of driving the crawler, fixed on the traveling motor, and transmits the driving force of the traveling motor to the crawler through the gear structure. Usually 1 on each travel motor. Idler wheel: plays the role of guiding the track and is located at the end opposite to the driving force. Usually there are 2 per excavator.

Final Drive & Swing Components for excavator: Planetary volvo excavator sprocket must withstand the high forces of torque generated by the engine and transfer these loads to move the equipment. All volvo excavator sprocket and final drive gears are manufactured to precise tolerances for reliable operation. The manufacturing method includes a heat treatment process that increases bending strength, prevents case crushing and provides exceptional wear resistancefor a long service life.

Hitachi ex60 track adjuster assemblies are available to suit most makes and models of Excavators and Dozers. A track adjuster assembly consists of a recoil spring,cylinder and a yoke, It is made by forging, heat treatment.All adjusters are manufactured to OEM specifications, are fully inspected and tested to ensure correct fitment and performance.